📖 AirTool Wiki
Power Tools
v2Model-specific guide · Generated 18 June 2026
How to use Power Tools
Usage notes
- Connect the tool to a RCD-protected power outlet or ensure the battery is fully charged before starting
- Adjust speed settings or depth guides to match the material hardness, such as using lower RPMs for metal or higher torque for concrete
- Secure the workpiece with clamps and maintain a firm two-handed grip to prevent kickback during operation
- Allow the tool to reach full speed before engaging it with the workpiece for a clean and efficient cut
Safety advice
- Always wear ANSI/AS/NZS rated safety glasses and hearing protection to guard against debris and noise hazards
- Use a dust mask or respirator when cutting wood, masonry, or metal to avoid inhaling fine particulates
- Ensure the blade or bit is appropriate for the material and check that it spins freely without wobbling before use
- Refer to NZ WorkSafe guidelines for electrical safety, ensuring cords are kept away from water and heat sources
Maintenance
- Wipe down the exterior housing and vents with a dry cloth after each use to remove dust and moisture
- For battery-powered tools, clean the battery contacts with a dry cloth and store batteries in a cool, dry place away from direct sunlight
- Inspect blades and brushes regularly for wear, replacing them when teeth are dull or brushes are short to maintain performance
Further reading
General Power Tools advice
Usage
- Power tools are ideal for high-volume tasks like framing, decking, and plastering where manual tools would be too slow or inconsistent
- Always check the rental condition upon pickup, ensuring cords are intact and guards move freely, as pre-existing wear is common
- Match the tool’s capacity to your project needs, such as using a 4-inch grinder for precision cutting and a 9-inch model for larger stock removal
- Finally, verify that the correct accessories (blades, discs, bits) are included and compatible with the specific tool model you have rented
Safety
- Always wear ANSI-approved safety glasses and hearing protection, as power tools generate significant noise and flying debris
- Use a Residual Current Device (RCD) for all electrically powered tools to prevent electric shock, especially when working outdoors or in damp conditions
- Secure workpieces with clamps or vice grips rather than holding them by hand to prevent kickback, particularly on circular saws and angle grinders
- For concrete drilling, wear a fitted dust mask (P2 or P3) to protect against silica dust, which is a key health hazard
About this page: Content is AI-generated from web sources and the local knowledge model. Always refer to the manufacturer manual and follow WorkSafe NZ guidelines for your specific tool and task.· v2